• Share:
Home Security: How to Increase Entry Door Security

Install special door and jamb reinforcement plates to keep burglars from breaking into your home. It only takes an hour.

By the DIY experts of The Family Handyman Magazine

Install door reinforcement hardware

You can spend hundreds on a fancy “pick-proof” dead bolt for your entry door. But you're kidding yourself if you think that'll stop most burglars. The truth is, most don't know how to pick a lock. They gain entry with one really well-placed kick or body slam that splits the doorjamb (and often the door as well), and they walk right in. You can stop burglars in their tracks by beefing up your door and jamb with reinforcing hardware. The components cost about $120 and take about an hour to install. Here's how to do it.

Start by measuring the entry door thickness and the spacing between the entry knob and the dead bolt cylinder. Then buy either a single or a double wrap-around door reinforcement plate kit (less than $20 at any home center or hardware store) and four 1-1/2-in.-long stainless steel wood screws. Then get a doorjamb reinforcement kit (StrikeMaster II is one brand; around $80 from homedepot.com or through our affiliation with amazon.com).

Remove the entry knob and dead bolt cylinder. Then remove the dead bolt and latch and toss the short screws. Install the wrap-around door reinforcement plate and reinstall the latch and dead bolt plates using the longer stainless steel screws (Photo 1).

Install jamb reinforcement hardware

Next, mark both the latch and the dead bolt “centers” on the strike side of the jamb (Photo 2). Remove the latch and strike plates and weather stripping from the jamb. But leave any weather stripping that's attached to the door stop. Then align the reinforcement plate, predrill a few mounting holes and add screws (Photo 3). Check the reinforcement plate alignment before snugging the screws by hand. Do not overtighten.

If the prescored dead bolt knockout lines up with the marking along the jamb, remove it and finish installing the remaining screws. If it doesn't line up, drill a new dead bolt hole with a 3/4-in. bimetal hole saw. Finally, replace two screws in each hinge with the longer screws provided in the kit.

Back to Top

Required Tools for this Project

Have the necessary tools for this DIY project lined up before you start—you’ll save time and frustration.

    • Tape measure
    • Drill/driver, cordless
    • Drill bit set

You also might need a 3/4-in. bi-metal hole saw.

Required Materials for this Project

Avoid last-minute shopping trips by having all your materials ready ahead of time. Here's a list.

    • Door and jamb reinforcing plates

Comments from DIY Community Members

Share what's on your mind and see what other DIYers are thinking about.

1 - 5 of 5 comments
Show per page: 20   All

October 20, 9:22 AM [GMT -5]

How about an electronic peephole It takes a pic of those coming to the front door and records it.

I also like an electronic door deadbolt. Like schlage it doesn't have a motor so you have turn the knob but that makes the battery last up to 3 years. if it is easier to unlock you will be more likely to lock it.

September 17, 4:39 PM [GMT -5]

These are really good tips. There is more information on this and some other DIY home security tips here: http://yourlocalsecurity.com/resources/diy-home-security.html

May 19, 11:36 AM [GMT -5]

Hey, good idea! However the most important for most doors is to reinforce the "Strike"

(go to amazon, home depot etc and search reinforced door strike) and to fix it with several 3 inch screws.

except for unsecured garages, most home break ins are by door kick down. takes about 10 seconds. The jamb breaks easily unless reinforced.

March 19, 4:27 PM [GMT -5]

Some really great ideas! And, now, one more. What a wonderful sound when a 12 ga. pump is pumped. Just sayin'.

January 26, 8:44 AM [GMT -5]

the next step is to get a reliable home security system. Preferably a wireless system that uses cellular technology to connect to monitoring. Http://www.simplisafe.com/wireless-alarm-system is a good place to start looking. Combine this with those reinforced door locks, and youve got yourself a veritable fortress.

+ Add Your Comment

Add Your Comment

Home Security: How to Increase Entry Door Security

Please add your comment

Log in to My Account

Log in to enjoy membership benefits from The Family Handyman.

  • Forgot your password?
Don’t have an account yet?

Sign up today for FREE and become part of The Family Handyman community of DIYers.

Member benefits:

  • Get a FREE Traditional Bookcase Project Plan
  • Sign up for FREE DIY newsletters
  • Save projects to your project binder
  • Ask and answer questions in our DIY Forums
  • Share comments on DIY Projects and more!
Join Us Today

Report Abuse

Reasons for reporting post

Free OnSite Newsletter

Get timely DIY projects for your home and yard, plus a dream project for your wish list!

Follow Us