How to Prevent Bathroom Mold

The first step to prevent bathroom mold is keeping tile dry

Next Project

Introduction

Once established, mold around a bathtub or shower can be hard to get rid of, but using these techniques for eliminating bathroom moisture can help keep it under control.

Tools Required

  • Scrub brush
  • Sponge
  • Squeegee

Materials Required

  • Bleach
  • Detergent
  • Grout sealer

Eliminating moisture from the bathroom

No matter where you live, a high moisture level in your bathroom makes mold almost impossible to get rid of, no matter how much you clean. Eliminating bathroom dampness is the key to keeping bathroom mold from growing. To do that, follow these steps:

Project step-by-step (3)

Step 1

To prevent mold on bathroom walls: Squeegee

Family Handyman

First, after a bath or a shower, squeegee water off the shower walls. That eliminates at least three-fourths of the moisture that supports mold and mildew growth.

Mold Remediation: How to Remove Mold

Step 2

Bath fan

Second, run your bath fans during your bath or shower and for a half hour after to flush out moisture. Or add a timer switch to make this step automatic.  Check the cfm volume of your fan, usually marked on a label under the grill. Replace it with a larger model if it’s too small for the size of your bathroom.

10 Tips For Removing Mold and Mildew

Step 3

Grout sealer

tileromarti/shutterstock

Third, if you have tile, seal the grout lines annually with a standard grout sealer to waterproof them.

To get rid of the current bathroom mold, scrub with detergent and water, then let the surface dry completely. Or use a solution of 10 percent bleach and 90 percent water (a stronger bleach solution will not give better results). Spray or brush on the solution, let it sit 10 minutes, then rinse it off and let dry.

If the fans aren’t clearing out most of the moisture in your bathrooms after five to 10 minutes, your fans may not be moving enough air. Fans are certified by the volume (cfm, or cubic feet per minute) of air “exhausted” out of the room. To find the recommended fan capacity for your bathroom, simply multiply the bathroom square footage by 1.1 (assuming an 8-ft. ceiling; for a 9-ft. ceiling, multiply by 1.5).

How to Test for Mold