Universal Outfeed Support
Need a hand to support jumbo workpieces at the table saw, drill press, band saw, router table or planer? You’ll work a lot safer and easier and achieve better results if you grab some scrap wood and construct this stand.
Check out the complete plans and how to build it.
Dead-Center Drawer Handles
Here’s a quick and easy way to perfectly center drawer handles and pulls and mark them for drilling. Use a straightedge and light pencil lines to mark diagonals from the corners of the drawer face to pinpoint the center. That’s all you’ll need for a single screw handle. For handles with two holes, adjust a try square to the center point and scribe the horizontal handle line. Divide the handle hole spacing (usually 3 or 4 in.) by two and mark the drill holes on the line on either side of the center. Thanks to Nick Paynter for this top-drawer tip.
Find the geometry of things by making sure a square is a square before leaving the home center.
Nail Bed for Trim Painting
Need to spray-paint or varnish a raft of trim pieces for that bedroom remodeling job? Here’s a cushy way to finish pieces without rotating or repositioning them. Cover a sheet of extruded polystyrene ($10 at a home center) with 1-mil painter’s plastic. (Spray paint will eat away at unprotected foam.) Now stick crisscrossed nails into the foam to hold up the pieces, then line up the trim and start painting. Thanks to Tom Lant for this great tip.
We’ve got the answer to the age-old question: paint trim or walls first.