Tapered Legs on a Thickness Planer
Using plywood or particleboard, make a skid for the legs, elevating them on one end with a wood strip to control the amount of taper. (This is the red strip in the photo.) Screw cleats on the skid to hold the legs while they go through the planer.
Taper one side, taking 1/16 in. per pass, then rotate each leg one turn and taper the next side. Add a second strip (shown in blue) and taper the remaining two sides. Note: Stop the taper 2 in. from the end when planing the last two sides so you’ll have ﬂat areas for attaching apron boards.
Our thanks to reader Robert Brundage for this slick, timesaving tip.
Quick-Wind Cord Holder
Tired of untangling those long extension cords every time you need one? Cut notches in the ends of a scrap board, glue in a couple of 1/2-in. dia. dowel handles and reel in every cord in your shop. There’s enough room for 150 ft. of medium-duty (14-gauge) cord if you cut the holder the same size as ours.
Easy Glue Bottle Cap
A medium-duty hollow wall anchor is the best glue bottle cap we’ve found. The narrow rectangular tip seals the opening of every glue bottle we tried. And the hollow wall anchor is much larger than the cap—so it’s that much harder to lose. Or try swapping out the cap with one that closes.