Save space and make plywood cutting easier by building this hinged, flip-up, open-web bench. It’ll take some care and patience to cut the interlocking joints, but after that, assembly is a cinch. Make everything from 1x4s. The bench shown is about 3 x 5 ft.—a good size for nearly any plywood cut. Keep the screws at least 1/4 in. from the top edge. Get it out of the way by tipping it up against the wall and locking it into place with a wooden turnbuckle, turned behind a 1×2 catch block that’s mounted with the thin side against the front board.
The grid work provides solid, even support for sawing or finishing. But make sure to set your saw to cut only 1/8 in. into the table so you don’t hit any of the assembly screws or weaken the table. Thanks to Bob Dawson for this cutting-edge tip.