The Family Handyman
The problem with most featherboards is that they’re nearly impossible to clamp so they stay put. But here’s an improved version that stays right where you clamp it on a table saw or router table. And it’s simple to build from a couple of scrap boards.
Here’s how: Cut a 45-degree angle on the end of a 4-in.- wide hardwood board and saw the “feathers” 3 in. long into the angled end. Attach a second board at a right angle midway along the first board with pocket screws, biscuits or dowels. Presto, you’re done! You’ve created a feather board with two clamping points. Adjust and clamp it right where you want it, and it’ll maintain uniform pressure on workpiece after workpiece without slipping.
Many thanks to furniture-making pro Bruce Kieffer for this great tip.