Better Glue Bottle Cap
Screw the ﬂip-up, 1-in. inner dia. cap from your shampoo or liquid cleanser bottle onto your glue bottle. The 1-in. cap ﬁts on every glue bottle we tried. Now:
- You can’t lose the little cap.
- Glue stays fresher because the cap snaps shut.
- The cap’s small round hole makes it easier to control the size of the glue bead.
- Glue doesn’t harden in the cap and require clearing before use. — Dorothy Nanchu
Worm Blower Glue Injector
Reader P. J. Mullanney has a novel use for a Worm Blower (a small plastic bottle with a syringe tip used to inﬂate an earthworm so it ﬂoats and attracts ﬁsh). Use a Worm Blower to inject glue when repairing splits and cracks in projects. The air-powered needle tip shoots glue deep into the crack for a long-lasting repair. Just be sure to clean the glue from the syringe tip by squirting hot water through it when you’re ﬁnished.
Big Clamp Stabilizers
These grooved blocks will hold the bar clamps upright so they won’t ﬂop over when you tighten the boards in the clamps.
To make them, use your table saw to cut a 3/4-in. deep slot midway along the face of a 2×4. You want a snug ﬁt for the bar, so stop and test-ﬁt it in the slot as you widen the slot with additional passes. Now crosscut the slotted 2×4 into 4-in. long blocks, press the bars into the slots, and glue that tabletop without the maddening clamp ﬂops! P.S. Slotted blocks work well to hold round pipe clamps, too, as long as you cut extra-snug slots.