Onboard Glue Spreader
For years I used my finger to spread glue beads on the edges of boards. Then, in sweaty haste, I'd wipe my fingers on my pants and another pair of nice jeans would become 'work-only' attire. To make the job less messy, all you need is an old credit card (or new, your choice), a 3/4-in.two-hole EMT conduit strap (about 50? at a home center) and two 1/8-in.nuts and bolts. Crook the conduit strap in a vise to level the conduit strap wings with the bottle cap. This way the credit card stays flat when you bolt it on. Drill a couple of window holes in the middle of the credit card so you can monitor the size of the glue bead, then drill bolt holes in the end of the card, snap the conduit strap onto the bottle cap and bolt on the card. Practice applying glue on a scrap board and in a few minutes you'll get it down (pun intended). Be sure to use fresh glue—the lightly bending card will spread it like butter. Want to get really good at edge-gluing boards? This video and these 10 tips teach you everything you need to know.
The Family Handyman
Tape Does the Trick
There’s no better way to clamp wood edging strips to plywood shelves than with pieces of masking tape. Just apply your glue to the backside of the strip and secure it with pieces of tape every 3 in. or so. Always cut your edging an inch longer to save the hassle of trying to align the ends perfectly. The excess length is easy to trim off later with a fine-tooth handsaw.
The Family Handyman
Always-Full Glue Bottle
Is your glue bottle half full or half empty? Now no matter how much glue is in the bottle, it seems like it’s full because when you store the bottle upside down in this handy stand. To make it, take a 3 x 3-in. block of wood and drill a 1-1/4 in. hole in the middle a little deeper than the wide part of the cap. Next, drill a 5/8-in. hole for the neck as shown. Thanks to Bruce Kieffer for this timesaving tip.