Edge-Gluing Made Easy
These clamps apply pressure horizontally as well as vertically, so the joint edges are wedged tightly together and stay level. To make the clamps, drill 3/8-in. holes (spaced 1 to 1-1/2 in.) along 5-ft. hard maple 2x2s. Then cut two 3/4-in. x 8-in., 20-degree tapered wedges for each clamp. At the hardware store, buy six 5-1/2 in. x 3/8-in. carriage bolts, washers and Wing-Nuts.
To set up the clamps for gluing a panel, slide the boards you’re gluing into the clamps without glue. Then push the bolts into the holes, allowing space for the wedges to be hammered in between the bolts and boards. Slide out the boards, apply glue to the edges, and put them back in the clamps. Tap in the wedges while checking along the joint lines to make sure the surface is even.
Free Glue Spreaders
Pick up a few free laminate samples on your next trip to the home center and put them to work as glue spreaders, nailing shields, shims, scrapers and spacers. Use them once and you’ll discover a dozen other ways they can improve shop life. Thanks to Ron Kapala for this tip.
Precise Gluing Tool
Oral syringes are perfect for injecting wood glue into narrow crevices for furniture repairs, according to reader Jim Tennessen. Hot water cleans the syringe in a ﬂash.