Cover Bar Clamps With Wax Paper
When you use steel bar clamps or pipe clamps, and wood glue comes in contact with the clamp, the moisture in the glue can cause the steel to leave a dark mark on your wood. Lay a sheet of wax paper over the clamps to prevent this “dark spot” problem. It will also catch glue drips that would otherwise get all over your clamps and workbench.
Rub the Joint
One good way to ensure a strong glue joint is to use the 'rub joint' method. Simply apply glue to the edges of one or both boards and rub them together to help spread the glue evenly before clamping.
Add One Board at a Time
When you're gluing several boards together, it can be difficult to get all the top surfaces perfectly aligned. Here's a tip that solves the problem. Rather than glue and clamp all the boards at once, add one board at a time. Let the glue joint set for about 20 to 30 minutes, then release the clamps and add another board. This method will take a little longer. But it makes it a lot easier to keep all of the boards' top surfaces flush, which makes for much easier flattening and sanding of the surface.