Tools & Materials
- 1×8 oak board
- 5/8-in. oak dowel
- Wood glue
- 3/4-in. spade bit
- 5/8-in. Forstner bit
Cut the Parts
Measure, mark and cut a 15-in. piece and 2-in. piece from the 1×8 board. We used a circular saw, but a miter saw will also work.
Cut two 9-in. pieces from the 5/8-in. dowel.
Drill the Holes
Use a 3/4-in. spade bit to drill two holes 4 in. from the bottom of the 15-in. board and 1-1/4 in. from the sides. The 5/8-in. dowels should slide through the holes easily.
Use a 5/8-in. Forstner bit to drill two partial holes 1-1/4 in. from the sides and centered from the top and bottom of the 2-in. board. Do not drill all the way through the board. The 5/8-in. dowels should fit snuggly in these depressions.
Assemble the Stand
Add a drop of wood glue inside the depressions in the 2-in. board and insert the 9-in. dowels. Allow the glue to dry. Lightly sand any rough edges and your tablet stand is complete!
When you’re ready to use the stand, insert the dowel assembly into the holes in the 15 in. board, leaving space to place your tablet between the 2-in. board and the 15-in. board. Then pull up your favorite recipes!
Bonus: When not in use, this two-piece tablet stand can be disassembled and stored in a cabinet or drawer.