Making a wood cutting board assembly steps
Learn how to make your own cutting board with the following step-by-step instructions.
Photo 1: Mark the curves
Drill 1/2-in. holes centered 3/4 in. in from the ends of the walnut strips. Then lightly clamp all five boards together so you can scribe the arcs on the ends.
Photo 2: Assemble
Take the boards out of the clamp, saw and sand the arcs on each board, and then glue the assembly together, leaving the dowel handles unglued.
Photo 3: Finish up
Unclamp, sand both sides and drill a 1/4-in.-deep, 3/4-in.-diameter hole at each underside corner. Glue in the feet and dowel handles, then wipe on a couple of coats of Butcher Block Oil. That’s it—chop some veggies!
Slice, dice and serve in style on this easy, cutting-edge project from Chris Ryland. Before you start making a wood cutting board, we’ll show you a simple way to dry-fit the parts, scribe the arc and then glue the whole works together. We used a 4-ft. steel ruler to scribe the arcs, but a yardstick or any thin board would also work. Be sure to use water-resistant wood glue and keep your tray out of the dishwasher or it might fall apart. And one more thing: Keep the boards as even as possible during glue-up to minimize sanding later.
Required Tools for this Project
Have the necessary tools for this DIY project lined up before you start—you’ll save time and frustration.
- Cordless drill
- Forstner drill bits
- Miter saw
- Orbital sander
- Safety glasses
- Tape measure
Required Materials for this Project
Avoid last-minute shopping trips by having all your materials ready ahead of time. Here’s a list.
- Four 3/4-in. x 3/4-in.-diameter dowels (for feet)
- Three 20-in. x 3-1/2-in. maple boards
- Two 23-1/2-in. x 1/2-in. x 3/4-in. walnut strips (handle strips)
- Two 5-in. x 1/2-in.-diameter dowels (handles)