Taillight Replacement Made Easy

Updated: Mar. 01, 2023

Use the Internet to find great prices on parts

tail light replacementFamily Handyman
Replace a broken taillight assembly by ordering a new one online and installing it using two ordinary hand tools.

You might also like: TBD

Order and replace a broken taillight

Photo 1: Remove the nuts

Locate the nuts and remove them from the threaded studs using a deep socket and ratchet.

Photo 2: Replace the assembly

Snap new lightbulbs into the sockets and install the new taillight.

Your teenage driver used the car and returned it washed and with a full tank of gas. Isn’t it great that he’s become a responsible adult? Oh, wait, you notice that the taillight is broken, and he has “no idea how that happened.” Time to head off to the body shop? Nope—this is a job you can do with ordinary hand tools and the Internet.

Finding a replacement taillight assembly is easy. Simply enter “taillight” into your favorite search engine. You’ll be amazed at the number of hits you get. Most of the companies sell low-priced offshore “knockoffs” of the original equipment (OEM) parts. If you’re OK with an “aftermarket” version, make sure the seller lists it as CAPA certified. A CAPA-certified part is guaranteed to fit and perform like the original. But don’t end your search there. Many car dealers have set up consumer-friendly Web sites that sell OEM parts at discounted prices. (See “Dealer Internet Sites” below.) Check out these dealer sites before you buy an aftermarket version. We actually bought a genuine Honda taillight for less than the aftermarket version cost.

Car manufacturers use two different techniques to attach taillights to the body. One method uses threaded studs embedded in the taillight. The studs are inserted into holes in the sheet metal and fastened with nuts (Photo 1, top). For the second method see “The captive stud/socket method” below.

Once you have the taillight assembly disconnected, remove the lightbulb sockets by releasing the catch mechanism and twisting. If you haven’t replaced the bulbs in the past two years, now is a good time to do that, since you already have everything apart. Then install the sockets in the new taillight and reassemble.

The captive stud/socket method

Photo 1: Remove the assembly screws

Remove the screws from the trunk or lift-gate side of the taillight. These were hidden under covers.

Photo 2: Pry out the assembly

Pry the plastic stud out of the socket while pulling back on the taillight assembly.

The second method uses screws to secure one end of the light, and captive stud/socket fasteners on the other end (Photo 1). If your vehicle has the captive stud/socket arrangement, use a wooden or plastic tool to pry the stud out of the socket. Metal screwdrivers will scratch the paint.

Dealer Internet Sites






Required Tools for this Project

Have the necessary tools for this DIY project lined up before you start—you’ll save time and frustration.

  • 4-in-1 screwdriver
  • Socket/ratchet set
You might also need a wooden spatula.

Required Materials for this Project

Avoid last-minute shopping trips by having all your materials ready ahead of time. Here’s a list.

  • New taillight assembly