Paint Window Sashes Faster
Most DIYers slop paint onto the glass when painting windows, then scrape it off with a razor. But if you're good with a paintbrush, you can cut in along the glass. You won't have to scrape, and better yet, you'll leave the paint seal intact between the wood and the glass.
Load your brush and lay off the paint on the sash, staying about 1/2 in. from the glass. As soon as the brush is about half unloaded, go back and cut in closely. Let the brush bristles just barely touch the glass so the paint seals the tiny gap between the wood and the glass. If paint does drip on the window, scrape it off with a razor after it dries.
Groove Textured Ceilings
It's almost impossible to paint right next to rough-textured ceilings (a process called 'cutting in') without getting paint on the ceiling. Taping off the ceiling doesn't work either. The solution? Knock off the texture at the edge with a putty knife. Hold the knife at a 45-degree angle to the wall and run the blade along the edge of the ceiling. The blade scrapes away the texture and leaves a small groove in the ceiling. Clean out the groove with a duster or a dry paintbrush.
Now when you cut in along the top of the wall, the paintbrush bristles will slide into the groove, giving you a crisp paint line without getting paint on the ceiling. And you'll never notice the thin line of missing texture.
Cut in Quickly with a Steady Hand
Cutting in along trim that's not protected by masking tape takes a steady hand. And once you get the knack for it, you'll never want to fuss with taping trim again. Sure, cutting in can be hard for some DIYers, but you can learn to do it effectively.
Use a tapered paintbrush. The angled bristles uniformly unload the paint as you cut in. Dip the brush into the paint, then tap (don't wipe) each side against your container to knock off the excess. Brush the paint on the wall, about 1/2 in. from the trim. Then make a second pass, cutting in all the way to the trim. Avoid 'pushing' the paint with your bristles or you'll leave a ridge where you're cutting in. Apply just enough pressure to let the bristle ends glide next to the trim. To help keep the brush steady, move your entire arm as you paint instead of moving your arm only from the elbow down.