10 Fall Turf Tips from a Pro Greenskeeper
Most homeowners assume that at the end of the summer, their grass care duties are over. The truth is, fall is the time when your lawn needs you the most. That’s the best time to get it ready for spring. We wanted to know what the pros do on their turf, so we asked Riley Kieffer from Willingers Golf Club in Northfield, MN, for advice. Follow these steps and you’ll have the healthiest lawn you’ve ever had next spring when things start greening up again.
Remember to Water
If your lawn is thinning, check out these lawn repair tips.
Aerate to Allow Roots to Spread
If you have heavy soil, fall is the time to aerate. Do it when the soil is moist and before you fertilize. Aerating loosens the soil, which allows roots to spread and oxygen to penetrate. Follow these other turf tips to keep a healthy lawn.
Fertilize and Revitalize
Even though the lawn is beginning to turn brown, the roots are hard at work storing nutrients for the winter and the following growing year. Fall is the single most important time to fertilize.
Reseed Bare Patches
Drain Garden Hoses or Waste Money on Replacements
Gary Wentz, Editor-in-Chief
Three Easy Winterization Steps for Your Lawn Tractor
- Moisture inside an unused engine leads to corrosion. ‘Fogging’ the engine—spraying an oily mist into each cylinder—prevents this. All you have to do is remove the spark plugs and blast in some aerosol fogging spray (sold at auto parts stores). Then reinstall the spark plugs.
- Storing a battery that isn’t fully charged can lead to permanent damage, especially in cold weather. Connect the battery to a battery charger and charge it until you get a reading of 12.7 volts.
- Stored gas will slowly gum up the whole fuel system, and the repairs can be expensive. So add a fuel stabilizer such as STA-BIL or Seafoam to the gas tank before winter. (Adding stabilizer to your gas can year-round is also a good idea.) But remember that stabilizers aren’t effective in gas that contains ethanol. If you don’t know whether the gas contains ethanol, run the engine until the tank is empty.
Another tip: Cover the air intake and exhaust openings with plastic wrap or aluminum foil to keep critters from homesteading in your engine over winter.
Spray for Weeds
Winterize Your Sprinkler System
If you like number crunching and you have the original irrigation layout showing the gallons per minute (gpm) of each sprinkler head, divide the gpm of each zone by 7.5. That’ll give you the cubic feet per minute (cfm) you need to blow it out. Otherwise, rent a 10-cfm compressor and hose from a tool rental center.
Set the compressor air pressure regulator to a maximum of 80 psi for rigid PVC pipe systems, or 50 psi for flexible black polyethylene pipe. Then turn off the water supply and set the system timer to open just one zone. Next, open the manual drain valve at the end of that zone (if equipped). Then, connect the air line to the blow-out port, as shown. Close off both valves on the backflow preventer. Then remove the plug on the blow-out port and screw in a quick-connect hose adapter. Snap on the air hose and connect the other end to the compressor. Now blow out the line. The heads should pop up and spit out water. Disconnect the hose as soon as they run dry. Don’t overdo the blow-out—without water cooling the plastic gears, they can melt in less than a minute. Move on to the next zone and allow the heads to cool. Then go back and blow out each zone a second time.