Materials for How to Build a Desk Project
Note: All pipes are 1 in. dia. and threaded on both ends; all pipe fittings are 1 in.
- 70-in. pipe (1)
- 8-in. pipe (4)
- 6-in. pipe (4)
- 24-in. pipe (4)
- Tee fitting (6)
- Cap (4)
- Floor flange (4)
- IKEA Karlby countertop in walnut
- No. 12 1-1/4-in. wood screw (16)
Build the Legs
Attach tee fittings to both ends of the 70-in. length of pipe; then add two 8-in. lengths of pipe to both tees, as shown in the photos.
Note: For each piece of pipe that you add, spray a small amount of lubricant onto the threaded end, and then tighten it in the fitting as much as possible. A pipe wrench and an assistant are very helpful when building this desk!
Next, attach tee fittings to all four of the 8-in. pipes. Orient the tees as shown, so the next pipe pieces can be installed under the assembly. Screw a cap to one end of each 6-in. pipe; then attach the capped pipes to the tees, as shown in the photo.
Add 24-in. pipes to all four open tees, making sure to tighten each one as much as possible as you go. Then add a flange to the top of each 24-in. pipe.
Attach the Countertop
Unpack the countertop and lay it facedown on the floor. Flip the leg assembly upside down and place it on top of the countertop. The flanges should be resting on the underside of the countertop, as shown in the photo. Measure the distance from each edge of the countertop to each flange, making sure that you center the leg assembly along the underside of the countertop.
Drill pilot holes first, and then drive screws into all four holes of each flange. Once the countertop is attached, flip the desk right side up and you’re done.
Note: This desk was built to be tall enough for bar stools and can seat several people. You could make a smaller version by trimming the countertop and selecting shorter lengths of pipe for the legs.