How to Build Outdoor Stair Railing

Updated: Mar. 20, 2019

Tips for making rock-solid stair posts

outdoor stairsFamily Handyman
Decks and outdoor stairs can develop wobbly railings, often due to a wobbly bottom post. Here's how to do it right, without having to set the post in concrete.

You might also like: TBD

Anchoring rail posts at the bottom of deck stairs

This is key for how to build stair railing. In this article we’ll walk you through this and other best practices for how to build stair railing.

Deck step railing how to: Outdoor stair railing detail

An important step in building deck step railing is to stiffen up posts at the bottom of outdoor stairs or deck railings by bolting them on three sides.

The bottom post is the toughest post to make solid when you build outdoor stair railings. The usual technique is to bolt it to the stair stringers (the frame). But it’ll only be solid if the stringers are solid. That’s the challenging part.

How to build stair railing

First, build a level landing pad for the stair stringers. You don’t need to pour a footing. Just dig out and compact a minimum 4-in. thick gravel base, then pour a concrete slab or lay paving stones.

Lay out and cut the stringers. (See How to Build Deck Stairs for more information.) Make the bottom tread cut 1-1/2 in. shorter than the others. You’ll fill out this space with a 2-by “subriser” (see photo).

Fasten the top of the stringers to the deck. Rip a piece of treated 2-by lumber to match the height of the bottom riser, then screw this “subriser” to the bottom ends of all three stringers. The finished riser (cedar in our case) will cover it.

Cut each post to length, allowing them to run alongside the stringer to the ground. Then cut a 1-1/2 in. deep notch into the post so it sits over the stringer, flush with the outside face.

Tack the post into the framing, making sure it’s tight to the stringer and subriser. Then cut and nail treated 2-by blocks between the stringers and tight to the backside of the posts. Next drill two 1/2-in. holes through the stringer and the post. Hold them 1-1/2 in. from the top and bottom. Drill another 1/2-in. hole through the subriser, the post and the block behind it. You’ll need either an extra-long drill bit or an extension bit. Install 1/2-in. galvanized carriage bolts with washers and nuts. Tighten them firmly.

Finally, install the risers and treads as shown in the photo. The post won’t be as rock-solid as one set in concrete. You’ll still feel some give when you lean on it. But it’s strong—it won’t move unless the stairs move.

Note: When learning how to build a handrail, it’s important to confirm the handrail detail on this post design with your local building inspector to make sure it’s acceptable in your region.

Video: How to Build Deck Stairs

Required Tools for this Outdoor Stairs Project

Have the necessary tools for this DIY project lined up before you start—you’ll save time and frustration.

  • Adjustable wrench
  • Circular saw
  • Cordless drill
  • Drill bit set
  • Framing square
  • Level
  • Miter saw

Required Materials for this Outdoor Stairs Project

Avoid last-minute shopping trips by having all your materials ready ahead of time. Here’s a list.

  • Galvanized carriage bolts with nuts and washers (1/2in.)
  • Pressure-treated 2x lumber
  • Rot-resistant posts