Amazing Miter Joint Clamp
Make these amazing miter joint clamps now so that you have them the next time someone needs a frame.
Popular Videos
You’ll Use it Over and Over Again
Clamping up four mitered corners is tricky. You can buy specialty clamps for this, but I make my own. Here’s how to do it. Start with a long 1×4, as it’s easier (and safer) to clamp for making the angled cuts than a short piece. Mark out the blocks, and then drill a 1-in. diameter hole in the center of each one. The hole prevents the blocks from getting glued to your project. Cut 45-degree angles tangent to the hole, and then cut the blocks free from the long board.
Originally Published: May 10, 2018