Read more on Dishwasher Repair
Read Next : Dishwasher Repair Tips: Dishwasher Not Cleaning Dishes

Dishwasher not Draining

Three simple things to check if your dishwasher doesn't drain completely

Does your dishwasher not drain or not drain completely? You might need to call a repairman, but try these three simple tests first.

By the DIY experts of The Family Handyman Magazine

Poor-draining dishwasher

Things to check when your dishwasher won’t drain

First, check the drain-hose connection, drain-hose clamp, solenoid and power supply. If that doesn’t yield results, check the three things listed below.

Does your dishwasher drain completely, or is there always about an inch of water that in the bottom? Before you call a repair service, here are three simple things you can try when your dishwasher won’t drain that will take all of 15 minutes.

Check the filter in the dishwasher’s tub

Photo 1: Check the filter

You’ll find the filter either in the bottom of the tub, surrounding the base of the lower spray arm, or at the back (as shown).

Photo 1 detail: Clean away the crud

Clear any trash away from the filter.

Although most new dishwashers now have small built-in grinders, pieces of food (like popcorn) and even paper (like labels washed off jars) can still clog the filter.

You’ll find the filter either in the bottom of the tub, surrounding the base of the lower spray arm, or at the back (like the one shown). The latter has a cage held in place with two screws. Clear any trash away from the filter and, if necessary, remove the two screws holding the filter cage, clean it and check inside for debris.

Check the drain hose

Photo 2: Check the drain hose

Disconnect the drain hose (usually it’s the one with ridges) from the pump and try to blow through the hose to make sure it’s clear.

First, disconnect the power by either unplugging the dishwasher or turning off its circuit breaker. Then remove the toe-kick (the panel near the floor). The toe-kick is held in place by two or four small screws. Loosen the hose clamp and disconnect the drain hose (usually it’s the one with ridges) from the pump.

Try to blow through the hose (Photo 2) to make sure it’s clear. If it’s blocked, look for any kinks in the hose and straighten them. Also check the disposer inlet or pipe where the dishwasher drain hose connects under your sink. On older disposers, this inlet is prone to corrosion buildup. Clear the corrosion with a small screwdriver.

Test the drain valve

Photo 3: Check for a valve bracket

If you have a valve bracket (Photo 3), your dishwasher has a drain valve. To test the valve, push on the valve bracket to make sure it moves freely.

Most, but not all, dishwashers have a drain valve that keeps water from draining back into the dishwasher. If you have a valve bracket (Photo 3), your dishwasher has a drain valve. To test the valve, push on the valve bracket
to make sure it moves freely. If the valve’s frozen, the electrical solenoid that controls it is burned out and
needs replacing.

New manufacturer parts are usually available from appliance parts sources. Sometimes you can get a much less expensive used part from a used-appliance dealer. Search the Internet for “appliance parts” to find both.

Popular How-To Videos