This versatile cherry shelf goes together in a few hours, and with a quick-drying finish you can have it on the wall in a day. The extra-wide top makes it perfect for vases, antiques and collectibles.
Cut the 1-in. band and the cove moldings extra long. Fit the miter on one end, then mark the opposite end for cutting.
Measure the overhang on each end and adjust the top until it's centered.
Glue the band and nail through it into the top.
Add the 1/4-in. spacer and bottom board. Then finish up by fitting and nailing the cove molding.
Level the cleat and screw it to the wall. You can locate studs or use drywall anchors.
Sure, you can buy a shelf similar to this one at a discount store, but you won’t be able to choose the size or finish. We designed ours with a wider top to hold vases and other collectibles, but you can make yours bigger or smaller. Plus, you can finish it to match your room. The shelf is versatile and goes together fast—it would make a great gift. We made our shelf from cherry, but you can also make it from oak or pine for about half the cost.
Tips for building the shelf
We finished this cherry shelf with a coat of American Walnut stain (test the color on a scrap) and three coats of spray satin lacquer. Photo 5 shows how to mount the cleat that supports the shelf. Then you just drop the shelf over the cleat to hang it on the wall.
The Cutting List gives finished lengths for the top, front, sides, cleats and bottom. You can cut these to the exact width and length listed and nail them together. The lengths listed for the 3/4-in. x 1-in. bands and the 3/4-in. cove moldings are oversized. You’ll mark these pieces in place for an exact fit (Photo 1).
A complete Cutting List and a Materials List are available in pdf format in Additional Information below.