Protect water lines running through crawl spaces or near outside walls with a chase made from rigid polystyrene foam and ventilated with warm interior air.
Surround the pipes on all four sides with 2-in. rigid insulation, then create an inlet and an outlet for warm air at each end of the chase. Keep air flowing with a small duct fan.
A small duct booster fan will keep warm air flowing through the pipe chase.
For starters, forget about using fiberglass or the foam pipe insulation sold at home centers. At best, it provides an insulation value of R-3.8. That’s not enough to prevent frozen pipes during extended cold periods. Plus, it’s difficult to install on existing pipes, especially when the pipes run along the length of a floor joist. So we put our heads together and came up with a solution that can be adapted to most crawlspaces. One of the editors also used this fix to successfully insulate freeze-prone pipes on an outside wall.
Here’s how it works: Build a duct system around the pipes with 2-in.- thick rigid extruded polystyrene foam (R-10). It works by drawing heated household air through the foam duct and back into the house. Start by locating a spot near the pipes on one end of the crawl space near a wall and cut a 5 x 10-in. hole in the floor above. This exhaust hole should be near an electrical outlet. Cut another hole at the far end of the pipes to fit a conventional floor vent—the size is up to you.
Next, construct the duct by running the foam down a few inches below the pipes to create enough room for airflow. Glue the lengths together with foam construction adhesive and pin them with screws or nails until the adhesive sets up. Crosscut individual foam pieces to “cap off” any open joist areas. Cutting is easy with a circular or table saw.
Use the same method to encase vertical riser pipes and pipes that run along the length of a joist. Once all pipes are enclosed, glue on end caps.
Buy a duct booster fan (available in the HVAC department at home centers) and place it over the exhaust vent. Run the fan full time at low speed during freezing weather (that’ll only cost a few dollars per month).
Foam insulation is flammable and produces toxic smoke when burning. You must follow these safety precautions:
Have the necessary tools for this DIY project lined up before you start—you’ll save time and frustration.
Avoid last-minute shopping trips by having all your materials ready ahead of time. Here's a list.