How to Bleed a Hot Water Radiator and Clear a Steam Radiator Vent

A simple one-minute procedure does the trick.

If one radiator doesn't heat up but others do, try this one-minute fix first. It usually solves the problem.

By the DIY experts of The Family Handyman Magazine

TIME

Instant!

COMPLEXITY

Super Simple!

COST

Free!

Bleed a hot water radiator

If you have a hot-water heat radiator that’s not heating the cause is usually trapped air, and getting rid of it is simple. At the top of your radiator, look for a small valve like the one shown in Photo 1. Use a radiator key, 1/4-in. 12-point socket, or a flat screwdriver (depending on your valve type) and slowly turn the valve counterclockwise until water starts dripping out. This will release trapped air and let hot water into the cold fins. While you’re at it, you should repeat the process with your other radiators. Bleeding the radiators will lower the pressure in your system, so you might have to slowly add water to increase the pressure. Do this by opening, then closing, the valve on the water pipe above the boiler. In fact, you may need to add water while bleeding the radiator in order to purge the air from the system. This is where a helper will save on trips up and down the stairs. If you’re unfamiliar with your system, call a pro. How much pressure you need depends on how high the water has to rise. The basic rule is 1 lb. of pressure for every 2 ft. of rise. Your gauge may read in pounds, feet or both. A basic two-story house, with the boiler and expansion tank in the basement, needs 12 to 15 lbs., or 25 to 30 ft., of pressure.

Back to Top

Clear a steam radiator vent

Don’t confuse a hot water system with a steam system. Steam radiators have an air vent, like the one shown, about halfway down the side. Unfortunately, many of these air vents get painted over, plugging the air hole. Clear the air hole in the top of the vent with a small wire or sewing needle. If you’re still worried about the air vents working, consult a hot water/steam heat specialist.

Back to Top

Required Tools for this Project

Have the necessary tools for this DIY project lined up before you start—you’ll save time and frustration.

  • Fine wire

Radiator key