Building a Garage Storage Wall

Simple storage shelves and plastic bins transform this garage—instantly!

Overview

Joe is the set carpenter for The Family Handyman magazine. He's also a husband, new father, dog owner, hunter, pinball wizard, pool shark, fisherman and the proud owner of a brand new garage, which he built himself. But Joe had a problem— he's got a lot of stuff, and he needed a way to organize it fast (because he'd rather be hunting!). But he has almost no time (see the above list for why) and almost no cash (babies and garages don't come cheap). So Joe's quick, easy-on-the-wallet solution was to build simple shelves that could hold plastic storage bins. He built the whole project in less than a day, and it cost him $300 for 26 ft. of shelving (the bins were extra). His wife thinks he's a genius and so do we. (Joe's just happy he can go hunting.)

Back to Top

Build and assemble it quickly

Mark rail and leg parts after cutting your parts to length. (See Additional Information for a materials list and project illustration with measurements.)

Back to Top

Put the frame together

Keep things square by assembling the frame on top of a piece of plywood.

Back to Top

Install the shelves

A helper makes installing the shelves a lot easier.

Back to Top

Screw the unit to the wall

Screw the unit to the wall through the top rail every second or third stud to make it very stable.

Back to Top

Install the middle cleats for the sliding bins

Hanging the bins from cleats means you don't have to stack them on top of each other and you can easily slide them in and out.

Joe's Tips

Each storage unit is basically two frames tied together with plywood shelves. Buy your bins first so you can customize the height and depth of each shelf space. Remember to leave enough clearance space in front of your shelving units to open your car doors.

Small bins are great for storing screws, glue and painting supplies in the middle bays of each unit. The best bins for hanging are those with snap- lock lids. They allow you to hang heavier loads without worrying that the lid will come off.

The fussiest measurements are those for the center bay of smaller bins. If your width measurements are off by a quarter inch, the bins won't sit squarely between the cleats or will be too tight to slide easily.

If your garage floor sometimes gets wet, nail plastic feet to the bottom of the legs. (A set of four nail-on plastic feet costs $3 at home centers.)

You can paint the wood to give it a classy look or leave it bare. Painting it before you put it together is a lot easier than painting it once it's assembled.

Small bins work well for the middle bays.
Back to Top