Repairing the cable
1 of 3Underground connector
Use underground connectors to fix a severed cable.
2 of 3Photo 1: Join the wires
Insert the wires into the connectors, making sure the colors
match up, then tighten the screws.
3 of 3Photo 2: Seal the connection
Slide the heat-shrink tube over the connector. Use a heat gun to shrink it and seal the connection.
If you accidentally cut an electrical cable while digging or pounding in a fence post, you can repair it with a splice. First turn off power to the electrical device fed by the broken cable at the circuit panel. Then dig 12 in. on each side of the break in the wire and gingerly work your way to the cable. You'll find the cable anywhere
between 12 and 24 in. deep. When you locate the cable, use a noncontact voltage detector to ensure there’s no
power.
Replace the whole section of cable that you dug up with the same gauge UF (underground feeder) cable. Cut
the cable about 12 in. on either side of the break. Then strip back the sheathing 2 in. and the wire insulation
5/8 in. Use two special underground splice kits (sold at home centers) to connect the new cable section. Slide the heat shrink tube over one end of the cable, then connect
the wires to the brass connector (Photo 1). Do this on both ends of the new cable. Once the damaged cable is
replaced and the wires are joined with connectors, slide the heat-shrink tube over each connector (Photo 2). Heat
the tube with a heat gun until it shrinks tight on the connector and sealant bubbles out the end.
If you have a broken underground line and no clue where the break is, hire an electrician with an underground open/short locator. The electrician will
be able to locate and mark the underground
cable, determine how deep the cable is buried and pinpoint within a few inches where the problem exists.
