Frustrated by a Phillips screw that's starting to strip out? Salvage the situation with one of these tips before you go through the misery of drilling out the screw.
By the DIY experts of The Family Handyman Magazine:July/August 2011
Slip a box-end wrench over the hex-shaped
“boss” near the screwdriver
handle (if equipped). Then coat the
tip with valve grinding compound
and jam it into the screw head.
Push on the screwdriver while you
crank on the wrench.
Valve grinding compound gives the screwdriver tip more grip.
Get a solid grip on the impact tool.
Then smack the end with a hammer.
The blow automatically forces the
Phillips bit into the screw head and
twists it at the same time.
Impact tools are available at auto parts stores.
It's easy to strip out a Phillips screw, especially if you belong to the “more
torque is better” club. Rather than mangle the screw head and then have to
drill it out, try these tricks.
At the first sign of “slippage,” coat your Phillips screwdriver tip with valve
grinding compound (sold at any auto parts store). Then try removing the
screw (Photo 1). If that doesn't work, buy a handheld impact screwdriver (sold at auto parts store). Smack the screwdriver with a hammer (Photo 2). The
“shock and turn” motion usually frees up the screw.
Have the necessary tools for this DIY project lined up before you start—you’ll save time and frustration.
You'll also need a Phillips screwdriver with a good tip and a handheld impact screwdriver
Avoid last-minute shopping trips by having all your materials ready ahead of time. Here's a list.
Copyright © 2013 The Family Handyman. All Rights Reserved.