Lift your trailer wheel by pulling it onto these jacks. It's quick and easy. No moving parts.
By the DIY experts of The Family Handyman Magazine:April 2011
So you’ve thought ahead and bought a spare tire for your
trailer—good so far. But if you think you can just use your
car jack to do the heavy lifting, think again. Most car jacks
won’t raise the trailer high enough, and hydraulic jacks are
heavy and take up a lot of space. That’s why these special
lightweight jacks really come in handy.
The wedge-shaped aluminum EZ Jack (about $80 from cabelas.com) is perfect for trailers with tandem wheels. First, loosen
the lug nuts on the flat tire first. Then wedge the EZ Jack
under the good front tire and pull the entire trailer forward
(or place it on the back wheel and drive backward if it’s
a flat front tire). Then chock the opposite side. Swap out
the tires, then toss the lightweight jack (9 lbs.) back in your
truck and you’re good to go.
No lifting! Simply back the trailer onto the jack.
The Easy Lift Jack (available through our affiliation with amazon.com about $32) is
perfect for boat and utility trailers (up
to 2 tons). First, loosen the lug nuts
on the flat tire. Then match up
the cutout portion on the jack
to the trailer axle. Wedge the
teeth along the circular edge
into the road and pull the
trailer forward. Expect
some skidding until it
bites into the road surface.
Once it’s raised,
block the other wheel
with a wheel chock
and swap the tires.
Set the jack under the axle and pull the trailer forward.
Have the necessary tools for this DIY project lined up before you start—you’ll save time and frustration.
Avoid last-minute shopping trips by having all your materials ready ahead of time. Here's a list.
Copyright © 2013 The Family Handyman. All Rights Reserved.