We'll show you how to replace your old-style bathtub drain with a low maintenance lift-and-turn drain. Once you remove the old stopper, installing the new one is a breeze. So stop dealing with the lever-style drain that catches all of the hair in the tub and replace it with a new one that doesn't have the complicated linkage.
Buy a new lift-and-turn stopper to replace your old lever-style drain.
When the stopper in your lever-style bathtub drain won’t pop up anymore because the linkage is damaged or clogged, replace it with a much simpler lift-and-turn style drain.
The linkage in a lever-style drain attracts dirt and hair like a magnet, and must be cleaned regularly in order to keep the drain working properly. The lift-and-turn drain has no complicated linkage to dig out and clean—almost everything catches in the drain grate. Buy the replacement kit at hardware stores and home centers.
Unscrew the overflow plate and pull the upper linkage out of the overflow pipe. Pop out the drain stopper and remove the lower linkage as well. Tug firmly when extracting both parts of the linkage because they may bind inside the overflow pipe.
Cut a notch 1/4 in. wide and deep in the old stopper body with a mini hacksaw. Check progress frequently to ensure you don't cut into the tub. Wedge a 3/4-in. cold chisel into the cutout slot and pound counterclockwise with a hammer to free the stopper body (use caution when hammering so you don't scratch the enameled tub). Completely unscrew and remove the stopper body.
Slide in a new gasket. Then roll a pencil-sized bead of plumber's putty and press it around the underside of the new stopper body rim. Stick the jaws of 8-in. pliers into the stopper body grate and thread it into the drainpipe.
Photo 1 shows how to remove the overflow plate, the stopper body and linkage. The linkage may stick and be stubborn to remove. Grab hold of it and tug hard until it pops out. Screw on the new overflow plate once the linkage has been removed.
The toughest part of the job is removing the old stopper body, but it’s all downhill after that. Remove the old stopper body as shown in Photo 2. If you’re having trouble unscrewing it, try heating it with a hair dryer set on “high.” The heat may help loosen the old plumber’s putty. The old stopper body can also be cut out with a reciprocating saw and metal blade, but be very careful because it’s easy to cut into and damage the bathtub.
All that’s left is to install the new stopper body and stopper. Slide the new rubber gasket on top of the drainpipe under the tub and insert the new drain flange with plumber’s putty on it as shown in Photo 3.
Use the supplied bushing if the new threads are different from the old. Screw the stopper into the stopper body and congratulate yourself on a job well done.
Have the necessary tools for this DIY project lined up before you start—you’ll save time and frustration.
Avoid last-minute shopping trips by having all your materials ready ahead of time. Here's a list.