• Share:
Install New Car Carpet

Replace the old dirty carpeting in your car with new pre-formed carpeting. It'll only cost about $200 and take 3 to 4 hours to do a first-rate job.

By the DIY experts of The Family Handyman Magazine

  • COMPLEXITY
  • ComplexityComplexityComplexity Moderate
  • close X

    No special skills or tools needed, but you have to remove and reinstall seats and other parts.

Install New Car Carpet

Replace the old dirty carpeting in your car with new pre-formed carpeting. It'll only cost about $200 and take 3 to 4 hours to do a first-rate job.

By the DIY experts of The Family Handyman Magazine

Buy a new carpet and remove the old one

You got a great deal on a “preowned” vehicle, but the carpeting in the car is simply a disaster. It's too far gone for stain removers—new carpeting is the best solution. You can buy preformed carpet specifically for your car's make, model and color and install it yourself. In most cases, it'll only cost about $200 and take an afternoon to install.

Shop for carpet at an auto parts store or an auto carpet Web site. But make sure the carpet you buy is custom molded to fit your car's floor pan and hump. Better carpets include original factory features like a heel pad under the accelerator and brake pedal. Most manufacturers offer a “mass backing” that duplicates the padding and rigidity of the factory carpet, and an economy “poly” backing. Choose mass backing if you plan to keep the car, poly if you're going to sell it in the near future.

When the carpet arrives, unroll it and let it sit on a flat surface for at least two hours to lose its curl. While the carpet is “uncurling,” start removing the trim and seats to expose the old carpet for removal.

Buy a shop manual that includes trim removal instructions and diagrams. Detach the door sill covers and remove the kick panels from the bottom of the front pillars.

Unscrew/unsnap any trim pieces from the seat tracks so you can get to the four nuts that secure the seat to the floor pan studs. You may also have to remove the seat belt anchor bolts (you may need Torx bits for these bolts). Disconnect any electrical connectors under each seat and lift the seats up and out (call in a helper for this part). Then remove the rear seat cushion. If you have a console, remove the shifter knob and all the fasteners. Lift the console out of the vehicle and pull out the old carpet and pad. But don't throw out the old carpet just yet; you'll need it.

Remove the seats

Remove the Seats

Remove the four seat retaining nuts from the floor pan studs and disconnect the electrical connectors. Remove the seat and the console.

Install the new carpet

Vacuum the floor pan and check for rust. Treat rusted areas with a rust converter (such as Loctite Extend or naval jelly) and paint them with a rust-inhibiting paint.

Using the old carpet as a template, trace the cutouts onto the new carpet with chalk. Next, move the carpet into the vehicle and double-check your cutout marks with the actual stud and anchor points on the floor pan. When you're confident the marks are in the right places, cut X-shaped openings at each chalk mark. Fit the openings over the studs and feed the electrical cables through. Enlarge the openings to achieve a good fit.

Cut off excess carpet at the door sills and apply a light coating of spray adhesive such as 3M Spray 77 to the back of the carpet where it rides up onto the firewall. Then reinstall the seats and trim and reconnect the electrical connectors. Enjoy the look and feel of new carpet and buy a set of no-spill coffee mugs.

Back to Top

Required Tools for this Project

Have the necessary tools for this DIY project lined up before you start—you’ll save time and frustration.

    • Socket/ratchet set
    • 4-in-1 screwdriver
    • Drill/driver, cordless
    • Torx bit
    • Utility knife
    • Wrench set

Required Materials for this Project

Avoid last-minute shopping trips by having all your materials ready ahead of time. Here's a list.

    • New carpet
    • Rust converter
    • Chalk
    • Spray adhesive

Comments from DIY Community Members

No comments on the article have been posted yet. Be the first to add your comment!

You will be required to log in or create an account to post a comment.

closeX

Add Your Comment

Install New Car Carpet

Please add your comment
closeX

Log in to My Account

Log in to enjoy membership benefits from The Family Handyman.

  • Forgot your password?
Don’t have an account yet?

Sign up today for FREE and become part of The Family Handyman community of DIYers.

Member benefits:

  • Get a FREE Traditional Bookcase Project Plan
  • Sign up for FREE DIY newsletters
  • Save projects to your project binder
  • Ask and answer questions in our DIY Forums
  • Share comments on DIY Projects and more!
Join Us Today
closeX

Report Abuse

Subject
Reasons for reporting post

Free OnSite Newsletter

Get timely DIY projects for your home and yard, plus a dream project for your wish list!

Follow Us