Patch a Water-Stained Ceiling or Textured Ceiling

Patch a water-stained popcorn ceiling

1 of 4

Photo 1: Scrap off the damaged texture

Lay down a tarp and scrape off all the loose, flaking texture with a putty knife. Hold a scrap of cardboard underneath the damaged area to catch the falling flakes.

2 of 4

Photo 2: Block off the surrounding area

Pin a plastic tarp around all four sides of the patching area (stay 1 ft. away from the damage), and let the tarp hang at least 4 ft. down.

3 of 4

Photo 3: Spray the area with primer

Spray stain-blocking primer over the water-damaged area and let it completely dry.

4 of 4

Photo 4: Spray the texture

Shake the can of texture for a couple of minutes, and then screw the nozzle onto the valve stem. Hold the can 9 to 14 in. away from the ceiling. Squeeze the trigger with quick half-second bursts while sweeping the can over the damaged area. Allow the texture to dry for 24 hours before painting.

Once the ceiling is dry, remove any loose or flaking texture (Photo 1). Wear a dust mask and safety glasses to protect yourself from falling debris. Spraying the stain blocker and ceiling texture are downright messy affairs, so tarp off a work area as shown in Photo 2. Many aerosol paints don’t spray well upside down, but the stain-blocking primer in Photo 3 is designed to spray up (Kilz Upshot is available at home centers and hardware stores).

Applying the new ceiling texture (Photo 4) is the trickiest part of the whole project. The texture comes out fast and the propellant dissipates quickly. You’ll only get about four seconds of spray per can, so you may want to purchase an extra can and practice on a sheet of cardboard. The texture repair is designed to match the original white ceiling texture color, but you might have to repaint the entire ceiling to completely hide the patch.