Buying a used motorcycle
1 of 4
New chain and sprockets: $400 to $500
Press up on the chain to check tension. It shouldn't move
more than an inch. Then examine the sprocket teeth. The
wear on the leading and trailing edges of each tooth should
be the same. If one side is worn more than the other, both
sprockets and the chain must be replaced as a set.
2 of 4
Brake job: $125
Shine a flashlight through the
spokes to light up the inboard brake
pad. If the pad is worn to within
1/8 in. of the steel backing plate,
it's time to replace the set.
3 of 4
New tires: $300 to $500
Compare the tread depth with the height of the wear bar. If
the wear bar is close to or even with the tread, the tire is
worn out and must be replaced. Also, check for cracks in the
rubber. That's a sign of tire aging, requiring immediate
replacement.
4 of 4
Fork seal replacement: $300
Pry off the fork seal protective covers. Then run your fingers
along the fork to detect any fluid leakage. If your fingers
come up wet, the seals and the fluid must be replaced.
The price of used motorcycles
has gone through the roof
as more people buy
them to save on gas.
But without a good motorcycle buying guide it's easy to get
burned with a
lemon needing
hundreds in
repairs. Ryan
Scott, owner of
Blue Cat
Motors, has
been in the
motorcycle
repair business
for 10 years. He
shared with
us the most
commonly overlooked
problems
a used bike may
have.
The good news is
that you can spot
them yourself and avoid
a costly mistake with just a
15-minute look-see. Then, just as
you would for any used vehicle,
have it inspected by a certified
mechanic (motorcycle mechanic,
in this case) before you commit
to buy.
First, check for engine/transmission
leaks. An oil leak can
easily cost several hundred dollars
to repair and usually requires
immediate attention. Valve and
side cover leaks are the most
common, so start your inspection
with those two components.
But don't confuse an oil
weep with a leak. A weep looks
like a darkened grease spot and
is usually covered with dust or
road grit, and it isn't a deal
breaker. An oil leak, on the other
hand, looks and feels wet.
If the engine
is spotless, it
could mean the
owner keeps his bike
clean. If so, the rest of the bike
should be just as spotless. But
if it's not, be suspicious. The
owner may have degreased the
engine to mask an expensive-to-repair oil leak.
The Test Ride
Check out the engine and fuel delivery systems with a “cold-start”
test drive. When cold, the engine should start right up and idle
smoothly. As it warms up, it should accelerate with power and without
hesitation. The same goes for clutch lever operation and gear
shifting—smooth, with positive engagement. And you shouldn't
hear any knocking or metallic sounds coming from the engine or
transmission. After the test drive, let the engine idle. It should be
smooth with no coughing, idle speed variation or misfires.
Back to Top